FCP270 P0917YZ模块卡件使用配置教程

产品标题：FCP270 P0917YZ模块卡件使用配置教程

型号：FCP270 P0917YZ

品牌： FOXBORO

质保：七天验收期，质保期一年

交货期： 1-3个工作日

产品图片展示

产品详情资料：

FCP270 P0917YZ

高和低报警死区：以工程单位为单位的一个范围，高于报警条件（低死区）或低于报警条件（高死区），即使在报警条件消失后，报警状态位也可以保持设置。要清除报警状态，通道输入必须在死区范围之外。报警死区不应导致报警清除条件超出工程单位用户限值范围。例如，如果通道的工程单位范围为-1000.0至 10000.0，且高报警设置为 100.00，则高报警死区值范围为0.0至小于1100.0。1100.0或更高的死区将使高警报清除条件低于-1000.0个单位，使警报无法在限制范围内清除。用户偏移16位整数范围：-32768到32768 32位浮点，范围：-340282e 38到3.40282e 3 8。0.0（默认值）工程单位偏移，以更改输入通道的基准。该值在报警检查之前添加到通道上的缩放值。软件过滤禁用（默认）或启用控制是否对输入执行软件过滤。积分时间（ms）0（默认值）到4294967295 ms***软件筛选器达到输入值63.2%的时间（以毫秒为单位）。值为0表示软件筛选器已禁用。值为100表示数据将在100ms内达到其值的63.2%。

产品英文详情资料：

High and Low Alarm Deadbands: A range in Engineering Units above the alarm condition (low deadband) or below the alarm condition (high deadband) where the alarm status bit can remain set even after the alarm condition goes away. For the alarm status to clear, the channel input must fall outside the deadband range. Alarm Deadbands should not cause the alarm clear condition to be outside the Engineering Unit User Limits range. For example, if the engineering unit range for a channel is -1000.0 to 1000.0 and a High Alarm is set at 100.0, the High Alarm Deadband value range is 0.0 to less than 1100.0. A deadband of 1100.0 or more would put the High Alarm clear condition below –1000.0 units making the alarm impossible to clear within the limits.User Offset 16-bit Integer range: -32768 through 32768 32-bit Floating-point, range: -3.40282e 38 through 3.40282e 38. 0.0 (default) Engineering Units offset to change the base of the input channel. This value is added to the scaled value on the channel prior to alarm checking.Software Filtering Disabled (default) or Enabled Controls whether software filtering will be performed on the inputs. Integration Time (ms) 0 (default) through 4,294,967,295 ms Specifies the amount of time in milliseconds for the software filter to reach 63.2% of the input value. A value of 0 indicates software filter is disabled. A value of 100 indicates data will achieve 63.2% of its value in 100ms.